LOCTITE 603

Elementi i pogodnosti

Smesa za učvršćivanje visoke snage. Idealan za ležajeve. Za upotrebu samo na blisko postavljenim cilindričnim delovima. Visoka tolerancija na ulje.
LOCTITE® 603 je smesa za učvršćivanje visoke snage. Osmišljena za spajanje cilindričnih delova, pogotovo za sinterovane ležajeve i tamo gde se ne može garantovati stalna čistoća površina. Proizvod se stvrdnjava kada se nađe u prostoru bez vazduha između namontiranih metalnih površina i sprečava labavljenje i curenje usled udaraca i vibracija. Veoma je otporan na ulje.
  • Smesa zadržava visok nivo snage
  • Posebno pogodan za sinterovana ležišta
  • Visoka tolerancija na ulja
Pročitajte više

Dokumenti i preuzimanja

Tehnički podaci

Atesti agencije / Specifikacije NSF, WRAS
Boja Zelena
Ispuna praznine 0.1 mm
Površine Metal: Čelik
Vreme učvršćivanja 8.0 minuta

Saveti

Detaljan vodič

1. Preparation - Cleaning

Use LOCTITE® 7200 for easier removal of residues in case of old retaining adhesive. It is recommended to use LOCTITE® 7063 to degrease and clean surfaces prior to applying the adhesive. For gaps larger than 0.5mm or worn out shafts, bearing seats or keyways, use LOCTITE® metal-filled compounds.

2. Preparation - Activation

If cure speed is too slow due to passive metals or low temperature (below 5°C), use activator LOCTITE® 7240 or LOCTITE® 7649 (see cure speed vs activator graph in the TDS).

3. Application - For Slip Fitted Assemblies

Apply adhesive around the leading edge of the male component and the inside of the female component and use a rotating motion during assembly to ensure good coverage.

4. Application - For Press Fitted Assemblies

Apply adhesive thoroughly to both bond surfaces and assemble at high press on rates.

5. Application - For Shrink Fitted Assemblies

Apply the adhesive onto the shaft; heat the collar to create enough clearance for free assembly.

6. Equipment

Recommended dispensing equipment: IDH 608996 50ml Hand Pump or IDH 88631 Peristaltic handgun 97001. For full product selection contact our technical service team.

7. Disassembly

Apply localised heat to approximately 250°C; disassemble while hot. For corroded or seized parts, use LOCTITE® 8040 Freeze and Release.

Česta pitanja