Americas
Asia-Pacific
Europe
South Asia, Middle East & Africa
Body rework and rebuilding are common tasks in body shops. Identifying the scope of damage to select the right product is key. In this how to we show you an innovative rebuidling method for non-structural metal car parts. It is suitable for application where you might have used traditional tin soldering before. See our TEROSON® EP 5020 TR in action.
TEROSON® EP 5020 TR is a lead- and tin-free alternative to tin soldering and is ideal for rebuilding of car body metal surfaces. It is excellent for grinding and the removal of interior parts is not necessary if welding is not required—no open flame used. Try it out for yourself!
All repair and maintenance tasks shown should be done by professionals only. Please do not try this at home or if not qualified by professional education. Always follow car manufacturer's instructions.
Limitation of liability
Grind and rebuild the surface mechanically.
Clean and pre-treat repair area with TEROSON® VR 10 and a lint-free cloth.
Open TEROSON® EP 5020 TR cartridge and squeeze out a small amount of material until both adhesive components run equally. Clean tip. Apply the mixing nozzle and discard the first 5 cm of the adhesive.
Apply TEROSON® EP 5020 TR to the rebuilt area in a way that the area
is sufficiently filled with excessive material (between 3 and max. 5mm).
Keep the nozzle tip inside the material to avoid air bubbles.
Spread and shape TEROSON® EP 5020 TR with a spreader to rebuild the original shape.
TEROSON® EP 5020 TR is sandable after ~2.5 hours at 23°C. Warm cure at 60 °C object temperature for 15 minutes is recommended to accelerate curing. Use infrared heater. Do not use a hot air gun for heating.
Sand the material with P120 paper to achieve a smooth surface contour and restore original shape.
Remove abrasive dust with a lint free cloth soaked with TEROSON® VR 10.
The use of bodyfiller e.g. TEROSON® UP 210 is required. Apply and spread TEROSON® UP 210 to re-shape the repair area.
Both before applying body filler or as a step before paint work, you may use BONDERITE® M-NT 1455-W for metal conversion and corrosion protection.
ANSWERS TO YOUR MOST COMMON QUESTIONS
Limitation of Liability
The information provided herein, especially recommendations for the usage and the application of our products, is based upon our knowledge and experience. Due to different materials used as well as to varying working conditions beyond our control we strictly recommend to carry out intensive trials to test the suitability of our products with regard to the required processes and applications. We do not accept any liability with regard to the above information or with regard to any written or verbal recommendation, except if otherwise explicitly agreed and except in relation to death or personal injury caused by Henkel´s gross negligence or intention and any liability under any applicable mandatory product liability law. Please note that the information provided by us may not be current, complete and correct. It is not intended to serve as legal advice. Each user is solely responsible for assessing and ensuring compliance with any applicable law. The information is protected by copyright. In particular, any reproductions, adaptations, translations, storage and processing in other media, including storage or processing by electronic means, enjoy copyright protection. Any exploitation in whole or in part thereof shall require the prior written consent of Henkel & Cie. AG. Except as otherwise noted, all marks used in this sell sheet are trademarks and/or registered trademarks of Henkel and/or its affiliates.
