LOCTITE® 480
Features and Benefits
A rubber toughened, low viscosity, black adhesive ideal for impact applications.
LOCTITE® 480 is a black, low viscosity, rubber-toughened instant adhesive designed for close-fitting parts. It has excellent peel, impact and shear strengths and has a fixture time of approximately 90 seconds. It is suitable for use on metals, elastomers and plastics.
- Ideal for bonding metal to metal, to rubber or magnets
- Good resistance in humid environments
- For applications where shock resistance is required or shock or peel loads are present
Documents and Downloads
Looking for a TDS or SDS in another language?
Technical Information
| Application method, Recommended | Dispense system, Manual |
| Applications, Recommended | Bonding close fitting parts |
| Colour | Black |
| Fixture time, Steel | 90.0 sec. |
| Gap fill | 0.18 mm |
| Key characteristics, Recommended | Toughened |
| Operating temperature | -40.0 - 100.0 °C (-40.0 - 212.0 °F ) |
| Shear strength, Mild Steel (grit blasted) | 26.0 N/mm² (3800.0 psi ) |
| Viscosity | 200.0 mPa·s (cP) |
How to
Step by Step Guide
1. Preparation - Cleaning
It is recommended to use the correct LOCTITE® cleaner for the surface to be bonded (such as LOCTITE® SF 7063) to degrease and clean surfaces prior to applying the adhesive.
2. Preparation - Priming
To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 770 to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.
3. Preparation - Activation
If cure speed is too slow, use appropriate activator LOCTITE® SF 7455 or LOCTITE® SF 7455. Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.
4. Application
Apply adhesive to one side or part.Recommended dispensing equipment: for precise dispensing of small amounts of adhesive, use dispensing needles.
5. Assembly
Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7455. Spray or drop activator onto excess product.
Frequently Asked Questions
What does it mean when an instant adhesive (CA) is toughened?
Why is there a white haze on my parts around the bond area?
Why does my plastic crack when I use an instant adhesive (CA)?
Why does my plastic crack when I use an instant adhesive (CA)?
What health and safety (H&S) precautions do I need to take when using this adhesive?
Which products are food / drinking water approved?
LOCTITE® 480
A rubber toughened, low viscosity, black adhesive ideal for impact applications.