Americas
Asia-Pacific
Europe
South Asia, Middle East & Africa
During a car's life a lot of different paintwork damages can occur. There are environmental damages caused by stone chipping, bird droppings or car wash scratches. But also during the paint refinish process damages such as dust nibs, runs or orange peel can happen. Here we will show how to repair of a dust nib caused by a dirt inclusion into the paint.
Within this repair instruction we will be using our TEROSON® Premium Line Polishing Compound which combines the compounding and polishing step into one thanks to an agglomerate-based grain that breaks down to a finer grit during application.
All repair and maintenance tasks shown should be done by professionals only. Please do not try this at home or if not qualified by professional education. Always follow car manufacturer's instructions.
Limitation of liability
Clean and pre-treat with TEROSON® VR 10. Abrade the paint inclusion with sanding paper P1500 or P2000. Clean sanded surface with TEROSON® VR 100 using a lint-free cloth.
Apply TEROSON® WX 159 on white, hard pad or directly onto the sanded surface. Compound the sanded surface with a polisher in the direction of the sanding marks. Perform the compounding and polishing at low speed for the first 45 seconds, then increase the speed to use the finest grain for finish preparation. If more compounding is needed, reapply the compounding polish and repeat the above steps until done.
Then increase the speed to use the finest grain for finish preparation. Follow ideal rotation movement. Clean the surface afterwards from paste residues.
Apply TEROSON® WX 178 HP to a black, soft pad or directly onto the polished surface. Finish the polished surface with a polisher. Move slowly and evenly with overlapping motions (up and down then side to side). This should produce a glossy surface without holograms. After successful finishing, cleand the surface of finishing paste with a clean microfiber cloth.
To seal the newly finished paint, a protective coat is necessary. Apply TEROSON® WX 189 Protection Sealant to a soft pad (TEROSON® ET 193), hand puck (TEROSON® ET 196), microfiber cloth (TEROSON® ET 195) or directly onto the finished surface. After successful protection application, clean surface with microfibre cloth. The glossy surface is now sealed and protected.
There are different steps within a polishing process. Here you see the surface change from pre-polishing to protection. In our TEROSON® Polishing Compounds range we use the color coded caps to indicate for which step the product is used.
ANSWERS TO YOUR MOST COMMON QUESTIONS
Limitation of Liability
The information provided herein, especially recommendations for the usage and the application of our products, is based upon our knowledge and experience. Due to different materials used as well as to varying working conditions beyond our control we strictly recommend to carry out intensive trials to test the suitability of our products with regard to the required processes and applications. We do not accept any liability with regard to the above information or with regard to any written or verbal recommendation, except if otherwise explicitly agreed and except in relation to death or personal injury caused by Henkel´s gross negligence or intention and any liability under any applicable mandatory product liability law. Please note that the information provided by us may not be current, complete and correct. It is not intended to serve as legal advice. Each user is solely responsible for assessing and ensuring compliance with any applicable law. The information is protected by copyright. In particular, any reproductions, adaptations, translations, storage and processing in other media, including storage or processing by electronic means, enjoy copyright protection. Any exploitation in whole or in part thereof shall require the prior written consent of HENKEL SLOVENSKO, spol. s.r.o. Except as otherwise noted, all marks used in this sell sheet are trademarks and/or registered trademarks of Henkel and/or its affiliates.
