LOCTITE 609 General Purpose Retaining Compound
Features and Benefits
- Low viscosity
- Augments press fits
- Prevents loosening and leakage from shock and vibration
- Tested to the lot requirements of Military Specification Mil-R-46082B (this is a regional approval)
Documents and Downloads
Looking for a TDS or SDS in another language?
|Agency Approvals / Certificates / Specifications||ASTM D5363, MIL-R-46082B for existing designs|
|Application Method||Dispense Gun, Dispense System, Manual|
|Applications||For Close Fitting Cylindrical Parts, Retaining|
|Cure Type||Anaerobic Cure|
|Fixture Time||10.0 min.|
|Gap Fill||0.15 mm|
|Key Characteristics||Fluorescent, Shear Strength: High Shear Strength, Viscosity: Low Viscosity|
|Operating Temperature||-65.0 - 300.0 °F (-55.0 - 150.0 °C )|
|Shear Strength, Steel||2300.0 psi (15.0 N/mm² )|
|Specific Gravity, @ 25.0 °C||1.1|
|Viscosity||120.0 mPa·s (cP)|
Step by Step Guide
1. Preparation - Cleaning
Use LOCTITE® 790™ for easier removal of old adhesive residues. It is recommended to use LOCTITE® 7070™ to degrease and clean surfaces prior to applying the adhesive. For gaps larger than 0.5mm or for worn out shafts, bearing seats or keyways, use LOCTITE® metal-filled compounds or LOCTITE® 660™ Retaining Compound.
2. Preparation - Activation
If cure speed is too slow due to passive metals or low temperature (below 5°C), use activator LOCTITE® SF 7649™ (see cure speed vs activator graph in the TDS). Allow to dry.
3a. Application - For Slip-Fitted Assemblies
Apply adhesive around the leading edge of the male component and the inside of the female component. Assemble parts with a rotating motion to ensure good coverage. Wipe off excess adhesive.
3b. Application - For Press-Fitted Assemblies
Apply 360 degree beads of adhesive to both bond surfaces at the leading edges of insertion or engagement, and assemble at high press-on rates. Wipe off excess adhesive.
3c. Application - For Shrink-Fitted Assemblies
Apply the adhesive onto the male component; heat the female component to cause expansion for free assembly. Assemble components and allow temperatures to equilibrate. Wipe of excess adhesive.
Apply localized heat to approximately 500°F/260°C; disassemble while hot. For corroded or seized parts, use LOCTITE® 8040™ Freeze and Release.
For manual assembly of adhesive, the use of LOCTITE® Pro Pump or LOCTITE® Peristaltic Hand Pump is recommended to ensure a conistent application volume. For semi-automatic or fully-automated dispensing options, contact our technical service team for advice.