LOCTITE® 495 Instant Adhesive
Known as Loctite 495 Super Bonder Instant Adhesive
Features and Benefits
- General purpose colorless and transparent bonding
- Low viscosity for thin bond lines
- Ideal for quick repairs
- Reduced hazardous ingredients for improved occupational safety
Documents and Downloads
Looking for a TDS or SDS in another language?
|Application method||Dispense System, Manual|
|Applications||Bonding Plastic, Bonding Rubber, Repairing|
|Cure type||Moisture Cure|
|Fixture time, Steel||5.0 sec.|
|Gap fill||0.12 mm|
|Key characteristics||Fixture: Very Fast Fixture, General Purpose, Viscosity: Low Viscosity|
|Operating temperature||-40.0 - 120.0 °C (-40.0 - 250.0 °F )|
|Recommended for use with||Elastomer, Metal, Plastic, Porous Surface|
|Shear strength, Mild Steel (grit blasted)||14.2 N/mm² (2060.0 psi )|
|Viscosity||40.0 mPa·s (cP)|
Step by Step Guide
1. Preparation - Cleaning
It is recommended to use the correct LOCTITE® cleaner for the surface to be bonded (such as LOCTITE® SF 7070™) to degrease and clean surfaces prior to applying the adhesive.
2. Preparation - Priming
To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 770™ to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.
3. Preparation - Activation
If cure speed is too slow, use appropriate activator LOCTITE® SF 7452™ (see cure speed vs activator graph in TDS). Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.
Apply adhesive onto one side/part.
Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7452™. Spray or drop activator onto excess product.
For precise dispensing of small amounts of adhesive, the use of dispensing needles is recommended.