LOCTITE 4204 Instant Adhesive
Features and Benefits
Available sizes:
- Fixture time of 10 - 30 secs.
- Suitable for metals, rubbers and plastics
- Flexible
- Very high viscosity
- Solvent-free
Documents and Downloads
- 20 g Bottle 1.0/case - IDH 1376969
Size Case: 20 g Bottle
Quantity: 1.0/case
Looking for a TDS or SDS in another language?
Technical Information
| Application Method, Recommended | Dispense System, Manual |
| Applications, Recommended | Bonding Close Fitting Parts |
| Color | Ultra Clear |
| Fixture Time, Steel | 120.0 sec. |
| Gap Fill | 0.2 mm |
| Key Characteristics | Temperature: High Temperature |
| Key Characteristics, Recommended | Flexible, Gap Filling, Solvent Free, Temperature Resistant, Toughened, Viscosity: High Viscosity |
| Operating Temperature | -40.0 - 121.0 °C (-40.0 - 250.0 °F ) |
| Shear Strength, Mild Steel (grit blasted) | 16.5 N/mm² (2400.0 psi ) |
| Technology, Recommended | Ethyl Cyanoacrylate |
| Viscosity | 4000.0 mPa·s (cP) |
How to
Step by Step Guide
1. Preparation - Cleaning
It is recommended to use the correct LOCTITE® cleaner for the surface to be bonded (such as LOCTITE® SF 7070™) to degrease and clean surfaces prior to applying the adhesive.
2. Preparation - Priming
To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 770™ to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.
3. Preparation - Activation
If cure speed is too slow, use appropriate activator LOCTITE® SF 7452™. Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.
4. Application
Apply adhesive to one side or part.Recommended dispensing equipment: for precise dispensing of small amounts of adhesive, use dispensing needles.
5. Assembly
Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7452™. Spray or drop activator onto excess product.
Frequently Asked Questions
What does it mean when an instant adhesive (CA) is thermally resistant?
Why is there a white haze on my parts around the bond area?
Why does my plastic crack when I use an instant adhesive (CA)?
Do instant adheisves (CA) need to be refrigerated?
Which products are food / drinking water approved?
What health and safety (H&S) precautions do I need to take when using this adhesive?
LOCTITE 4204