LOCTITE 402 Instant Adhesive
Features and Benefits
- Ultra-performance adhesive
- Temperature resistance up to 135°C/275°F
- Unique, patented formula with reduced hazardous ingredients
- Perfect for quick repairs as well as high performance production applications
Documents and Downloads
- 500 g Bottle 4.0/case - IDH 2712746
- 20 g Bottle 12.0/case - IDH 2714628
Size Case: 500 g Bottle
Looking for a TDS or SDS in another language?
|Application Method||Dispense System, Manual|
|Applications||High Speed Production Bonding, Repairing|
|Cure Type||Moisture Cure|
|Fixture Time, Steel (grit blasted)||20.0 sec.|
|Gap Fill||0.15 mm|
|Key Characteristics||Fast Setting, For Difficult-to-Bond Materials, Temperature Resistant|
|Operating Temperature||-40.0 - 135.0 °C|
|Shear Strength, Mild Steel (grit blasted)||>15.0 N/mm²|
|Substrates||Elastomer, Metal, Plastic, Porous Surface|
|Viscosity||110.0 mPa·s (cP)|
Step by Step Guide
1. Preparation - Cleaning
It is recommended to use the correct LOCTITE® cleaner for the surface to be bonded (such as LOCTITE® SF 7070™) to degrease and clean surfaces prior to applying the adhesive.
2. Preparation - Priming
To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 770™ to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.
3. Preparation - Activation
If cure speed is too slow, use appropriate activator LOCTITE® SF 7458™ or LOCTITE® SF 7452™ (see cure speed vs activator graph in TDS). Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.
Apply adhesive onto one side/part.
Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7458™ or LOCTITE® SF 7452™. Spray or drop activator onto excess product.
For precise dispensing of small amounts of adhesive, the use of dispensing needles is recommended.