LOCTITE® 401

Features and Benefits

LOCTITE 401 is a general purpose, fast curing, instant adhesive that is ideal for use on porous substrates.
LOCTITE® 401 is a fast curing instant adhesive designed for the assembly of difficult-to-bond materials requiring uniform stress distribution and high tensile and/or shear strength. The product provides for the rapid bonding of a wide range of materials, including metals, plastics and elastomers. LOCTITE 401 is also suited to bonding porous materials such as wood, paper, leather and fabric. Perfect for all quick repairs and all types of small emergency repairs.
  • Universal instant adhesive
  • Very high strength on close-fitting parts
  • Perfect for all quick repairs and all types of small emergency repairs.
  • Bonds a wide range of similar or dissimilar substrates (metals, rubber, wood, cardboard, ceramics, as well as most plastics)
Read More

Technical Information

Application method Dispense system, Manual
Applications Bonding close fitting parts, Repairing
Colour Clear
Cure type Moisture cure
Fixture time, Steel 5.0 sec.
Gap fill 0.15 mm
Key characteristics General purpose, Strength: high strength, Viscosity: low viscosity, fixture: very fast fixture
Operating temperature -40.0 - 120.0 °C (-40.0 - 250.0 °F )
Physical form Liquid
Recommended for use with Elastomer, Metal, Plastic, Porous surface
Shear strength, Mild Steel (grit blasted) 20.0 N/mm² (2900.0 psi )
Viscosity 100.0 mPa·s (cP)

How to

Step by Step Guide

1. Preparation - Cleaning

It is recommended to use LOCTITE® SF 7063/7064 to degrease and clean surfaces prior to applying the adhesive.

2. Preparation - Priming

To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 7239 or LOCTITE® SF 770 to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.

3. Preparation - Activation

If cure speed is too slow, use appropriate activator LOCTITE® SF 7458 or LOCTITE® SF 7455 (see cure speed vs activator graph in TDS). Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.

4. Application

Apply adhesive onto one side/part.

5. Assembly

Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7458 or LOCTITE® SF 7455. Spray or drop activator onto excess product.